Filling Nail Holes In Trim Before Staining

Filling Nail Holes In Trim Before Staining. We used a pneumatic nail gun with an air compressor. Since the holes are quite small, the size of one fourth of a pea is enough to seal a nail hole.

DIY Nightstand with Bun Feet Shanty 2 Chic from www.shanty-2-chic.com

You can mix in a drop or two of stain to your filler before applying it, that seems to also allow the filler to accept more stain when you stain project. Then you can fill them in with spackling and paint over them. Filling nail holes and moulding gaps then staining.

Source: www.thespruce.com

The color putty comes in many shades and can be mixed together to get a match to the final finish. Keep in mind that the manufacturers of such products usually recommend applying stain within two hours of the conditioner's application, so after filling your holes and allowing the filler to dry, you may have.

Source: www.painttalk.com

Fill the holes after the first finish coat, so the 'smear' can be cleaned off. Since these are already painted (usually white), we are looking for good filling tricks for the nail holes that we can then touch up paint over.

Source: www.shanty-2-chic.com

Never fill holes directly over stain, or you will get smudges around the nail holes as the putty fills the pores of the wood. As a result, your trim may look dreadful.

Filling Nail Holes And Moulding Gaps Then Staining.

If you are using a joint compound, it will shrink as it dries off. Then you can fill them in with spackling and paint over them. Filling nail holes in trim.

Always Have At Least The Sanding Sealer Layer Of Finish On First So That The Wood Is Sealed And All You're Filling Is The Nail Holes, First Coat Of Finish Would Be Better Yet, But Some Folks Only Use Two Coats Of Finish.

Put the final finish coat *over* the putty. Never fill holes directly over stain, or you will get smudges around the nail holes as the putty fills the pores of the wood. You are taking on a big project it is not easy you will have first scuff sand everything clean it prime it with quality primer.fill all the nail holes dents etc.

Next Find The Matching Color Putty And Fill The Holes, Then Top Coat.

Fill in all cracks and imperfections, trim to wall and trim to trim, with a putty knife, fingers or anything that'll do it. Anding smooth once it's dry. Before nailing, apply pieces of masking tape to your trim and shoot your nails through the masking tape.

Filled Holes Should Always Be Darker, Not Lighter.

You can mix in a drop or two of stain to your filler before applying it, that seems to also allow the filler to accept more stain when you stain project. Cleans up with mineral spirits. Fill the holes after the first finish coat, so the 'smear' can be cleaned off.

To Avoid Those Blotches Around The Areas You Putty, Avoid Smearing It Over Large Areas.

We used a pneumatic nail gun with an air compressor. There is a product aptly named 'color putty' that is an oil/pigment mix. Definitely fill first, then stain, it wont be as visible.